Shandong Huaqiang Aluminum Industry Co., Ltd. is located in Dongcheng Economic Development Zone, Linyi County, Shandong Province. It is adjacent to the aluminum wholesale market in northern China and covers an area of ​​150 acres. The company has a good level of aluminum extrusion production lines, annual production capacity is 50,000 tons, and now has 400 employees.

Have to understand the industrial aluminum profile cutting requirements

[Abstract]:
The wall thickness of industrial aluminum profile is only 0.4mm, and its tolerance requirement is plus or minus 0.04mm.
The wall thickness of industrial aluminum profile is only 0.4mm, and its tolerance requirement is plus or minus 0.04mm. The extrusion process is very strict to equipment, tooling and process. Industrial aluminum extruders point out that this squeeze technique is often called precision extrusion.
 
The tolerance of some small precision industrial aluminum profiles is more than half that of the special grade of the JIS standard, and the size tolerance of the general precision industry aluminum profiles is between + 0.04 ~ + 0.07mm. Potentiometer with the precision of industrial aluminum profile for "︼" profile weight 30 g/m, the section size tolerance range of plus or minus 0 07 mm. Loom for "s" with the precision of industrial aluminum profile, section size tolerance of + / - 0.04 mm, angular deviation is less than 0.5 °, bending of 0.83 x L. A1050, A1100, A3003, A6061, A6063 (low, medium intensity alloy) small precision extrusion profiles, the minimum wall thickness of 0.5 mm, the minimum sectional area was 20. A5083, A2024, A7075, (middle, high strength aluminum alloy) small precision extrusion profiles, the minimum wall thickness of 0.9 mm, the minimum area of 110 mm.
 
Industrial aluminum profile cutting requirements:
 
The first point is that the length of the product of the industrial aluminum profile shall be determined before the cutting of the industrial aluminum profile, the size of the calibrated ruler shall be determined, and the first material shall be rechecked and fixed length.
 
Second, the surface quality and line size should be checked before cutting. The defective industrial aluminum profile will be marked. The defect will be cut out before cutting.
 
Third, cutting the end cutting Angle should not exceed 1.5 °, specified length to allow deviation to + 10 mm.
 
At the fourth point, it is necessary to keep the cutting saw table clean and not allow a large amount of aluminum chip to exist, so that the industrial aluminum profile should not be cut to avoid the surface of industrial aluminum.
 
Fifth, to prevent the cutting saw blade heating, the cutting should be oil cooling and lubricating industrial aluminum profile processing equipment.
 
At the sixth point, the end of the industrial aluminum extruding frame should be arranged, with horizontal bar between each layer, and the thickness of each horizontal bar should be consistent, not less than 4.
 
At the seventh place, there is a large or thick industrial aluminum profile, which must be between 50 and 100mm apart.
 
After the first at eight o 'clock, industrial aluminum frame, should count the root number, put the accompanying card, and note the frame number on the card, industrial aluminum specifications, length, root number, quality, production date, name of the captain and schedule requirements.

 

NEWS CENTER

Copright by Shandong Huaqiang Aluminum Industry Co., Ltd. Powered by:300.cn 鲁ICP备18019309号-1